User's Manual

ManualsBrandsSequel Technologies ManualsElectronicsSmoke Detector, Wireless

Rhein Tech Laboratories, Inc. Client: Sequel Technologies, LLC

360 Herndon Parkway Model: STWS-SMK

Suite 1400 Standard: FCC 15.231

FCC ID: V4X-SMKX01 Herndon, VA 20170

http://www.rheintech.com

Report #: 2008058

Page 20 of 26

Appendix G: Manual

Please see the following pages.

Summary of content (5 pages)

PAGE 1
Rhein Tech Laboratories, Inc. 360 Herndon Parkway Suite 1400 Herndon, VA 20170 http://www.rheintech.com Appendix G: Client: Model: Standard: FCC ID: Report #: Sequel Technologies, LLC STWS-SMK FCC 15.231 V4X-SMKX01 2008058 Manual Please see the following pages.
PAGE 2
Wireless Smoke Detector (SMK) Installation Instructions Sequel Technologies, LLC General Description The wireless, low profile, photoelectric smoke detector is based on the System Sensor i3™ series platform. The detector has a green LED to indicate standby within proper sensitivity and a red LED to indicate alarm, maintenance, and low battery. The detector features a state-of-the-art optical sensing chamber, a built-in sounder, and a mechanical test switch.
PAGE 3
SNAP OFF TAB FOR TAMPER LOCK TAMPER RELEASE TAB MOUNTING HOLES Figure 2: Tamper-Resistant Feature Installing the Mounting Base The mounting base can install directly to standard single-gang electrical boxes, 4-inch square or octagonal boxes, 3.5-inch octagonal boxes, or directly mounted to a wall or ceiling using drywall fasteners. 1. Select a sensor location using applicable requirements and the guidelines presented in the Installation section of this manual. 2.
PAGE 4
Maintenance Troubleshooting Cleaning 1. Place the system in walk test mode. 2. Remove the detector from the base by turning counter-clockwise. 3. Remove the top half of the screen/sensing chamber by lifting straight up (Figure 4). 4. Vacuum or use canned air to remove any dust or particles that are present on both chamber halves. 5. Replace the top half of the screen/sensing chamber by aligning the arrow on the screen/sensing chamber with the arrow on the housing.
PAGE 5
Specifications • Compatibility: All Sequel Technologies ST Security Systems (ST8 requires Expansion Transceiver Module) • Dimensions (including base): 5.3” x 2.0” (D x H) • Battery: 3.0V CR123A, Lithium battery (average battery life is 3-5 years) • Diameter (including base): 5.3 inches • Height (including base): 2.0 inches • Sensitivity: 2.5%/ft.