User's Manual

Rhein Tech Laboratories, Inc.

Client:

Sequel Technologies LLC

360 Herndon Parkway

Model:

STWS-DWS-SLIM

Suite 1400

Standard:

FCC 15.231

Herndon, VA 20170

http://www.rheintech.com

FCC ID:

V4X-SLIMDWS

Report #:

2009214

Appendix G: Manual

Please see the following pages.

PAGE 1
Rhein Tech Laboratories, Inc. 360 Herndon Parkway Suite 1400 Herndon, VA 20170 http://www.rheintech.com Ap p e n d ix G: Ma n u a l Please see the following pages. Client: Model: Standard: FCC ID: Report #: Sequel Technologies LLC STWS-DWS-SLIM FCC 15.
PAGE 2
Door/Window Sensor, Slim (STWS-DWS-SLIM) Installation Instructions Sequel Technologies, LLC Document Number: 520-00019 Rev. A General Description Reed Switch The Slim Line Door/Window Sensor (STWS-DWSSLIM) is a door/window sensor developed for use with the ST security systems. The sensor achieves enhanced wireless reliability using unique duplex narrow band frequency diversity, which transmits and receives radio signals on two separate frequencies.
PAGE 3
. To enroll the sensor, remove the circuit board from the cover, insert batteries in sensor and trip the sensor (move the magnet away from the reed switch)*. 4. Upon enrollment, the keypad emits one beep and the display shows the zone number and sensor ID. Replace the sensor on the mounting base. 5. Continue enrolling additional sensors if desired. When finished, press to exit. * The sensor will only enroll within the first 3 “routine” (reed switch) trips after power up.