User's Manual

5 ST User Manual
User Command Summary
Action LCD Keypad Command
System Operation
Disarm to Off / Cancel an Alarm
+ PIN Or Enter PIN
Arm Perimeter
+ PIN (if prompted)
Arm All
+ PIN (if prompted)
Arm with No Delay
Or + PIN + <No Delay>
Arm with Latchkey
Or + PIN + <Latchkey> + Enter Latchkey Time
Turn Chime On/Off
ON: NEXT + <Chime> + <On>
OFF: NEXT + <Chime> + <Off>
Turn All Lights On/Off (ST8 Only)
ON: NEXT + <Lite> + <All> + <On>
OFF: NEXT + <Lite> + <All> + <Off>
Turn Individual Lights On/Off (ST8
Only)
ON: NEXT + <Lite> + <Lite #> + Light # + <On>
OFF: NEXT + <Lite> + <Lite #> + Light # + <Off>
Alarms
Initiate a Police Alarm
Press and hold the POLICE button for two seconds
Initiate a Fire Alarm
Press and hold the FIRE button for two seconds
Initiate a Duress Alarm
Enter the four-digit Duress PIN to disarm the system
Programming
Enter User Setup Menu
NEXT + NEXT + NEXT + <Setup> + User PIN
Add a User PIN
Enter User Setup menu.
With the display showing PINS TIME DATE, select <PINS>.
The display will show PINS TO EDIT: 01
Enter user number to add and select <Done>. (e.g. To add user 09, enter 09)
Enter new pin and select <Done>. To confirm, enter new pin again and press
<Done> twice.
Note: For security, existing PINs are never shown
1.
2.
3.
4.
5.
Set the Time
Enter User Setup menu.
With the display showing PINS TIME DATE, select <Time>.
Enter the time (hh:mm). Select <AM> or <PM>.
Select <Done> to save and exit the menu.
1.
2.
3.
4.
Set the Date
Enter User Setup menu.
With the display showing PINS TIME DATE, select <Date>.
Enter month/day/year.
Select <Done> to save and exit the menu.
1.
2.
3.
4.
Connect for Remote Programming
(only if requested by alarm dealer)
Enter User Setup menu.
NEXT + <Connect> + <Ans> (Answer phone) or <Dial> (Dial phone) or <EIM> (Ethernet)
1.
2.
Register for Remote Programming
(only if requested by alarm dealer)
Enter User Setup menu.
NEXT + <Reg> + <EIM> (Ethernet) or <Dial> (phone) + <Cont> (Continue)
1.
2.
Testing and Maintenance
Phone Test
NEXT + NEXT + <Test> + PIN + <Comm>
Walk (Sensor) Test
NEXT + NEXT + <Test> + PIN + <Walk>. To exit walk test, press <Done>.
Viewing the Event Buffer
NEXT + NEXT + <Log> + PIN + <Prev> (previous event) or <Next> (next event)
Review System Status
NEXT + <Stat> + <Zone> or <Sys>
Review Zone Status
NEXT + <Stat> + <Zone>
Review Alarm Memory
NEXT + <Stat> + <Memry>
Reset Hardwired Smoke Detectors
NEXT + NEXT + <Reset> + PIN + <Done>