User's Manual

ManualsBrandsSequel Technologies ManualsElectronicsKeypad, LCD, 16X2

9 ST User Manual

Entry and Exit Delay

Exit Delay

After arming your system, the system will allow you time to leave through a designated exit

door without setting off an alarm. Exit delay begins immediately after an arming command

and applies to all methods of arming (unless No Delay is selected). A steady beep will sound

throughout the duration of the exit delay with fast beeps during the last 10 seconds.

Entry Delay

Upon re-entry through a designated entrance door, the system will allow you time to dis-

arm the system. If the system is not disarmed before the expiration of the entry delay time,

an alarm will occur. The keypad will beep during the entry delay period.

Chime Mode

Your system can be set to alert you to the opening of a door or window by using Chime

mode. When activated, the LCD keypad and interior sirens emit a tone whenever a pro-

tected perimeter door or window is opened. Chime mode can be activated only when the

system is disarmed.

To turn Chime on/off:

Press NEXT + <Chime> + <On> or <Off>

X10 Lights (ST8 Only)

The optional PSC-04 Module allows the system to control lights in your home that are

plugged into X10 lamp modules. Ask your installer if this feature is enabled with your sys-

tem. Lights controlled by your system can be turned on and off manually as follows:

To turn lights on/off:

Press NEXT + <Lite> + <All>

Select <Off> to turn lights off, or select <On> to turn lights on.

Press EXIT to exit the Light Menu.

To turn individual lights on/off:

NEXT + <Lite> + <Lite #>

Enter the light number (ID) of the light you wish to control and select <Off> or <On>.

Press EXIT to exit the Light menu.

•

Note: The exit and entry de-

lay times are programmed

by the installer. If adjust-

ments are needed, please

contact your installation

company.