User's Manual

Problem Action
The LED does
not blink when a
buon is pressed
on the KF5.
Replace the sensor’s battery. Test the
sensor after replacing the battery.
Testing the device allows the control
panel to receive a signal with the
new battery information.
•
Specifications
Compatibility: Sequel Technologies ST8 and ST
Express Security Systems
Power: 3.0V CR2032, lithium battery (average
battery life is 3-5 years)
Transmitting Frequency: 319.5 MHz and 345 MHz
Transmit Range: 500 feet, open air
Material: High-Impact ABS
Operating Temperature: 40°F to 100°F (0° to 38°C)
Storage Temperature: -30°F to 120°F (-34° to 49°C)
Max. Humidity: 90% relative humidity, non
condensing
Regulatory Approvals: FCC 15, UL (Pending)
FCC Notice
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Changes and/or modications not approved by Sequel Technologies,
LLC could void the user’s authority to operate the equipment.
FCC ID: V4X-KF5X01
•
•
•
•
•
•
•
•
•
Deleting the Keyfob
Enter program mode (NEXT + NEXT + NEXT +
<Prog> + Installer PIN).
The keypad will display “Devices Available.” Press
the appropriate function key to select ST (control
panel).
Press NEXT until the display shows <Modl>.
Select <Modl> and press NEXT until the display
shows “Delete Device.”
Press # to scroll to the appropriate device to delete.
I.e. If you wish to delete device 5 press # until the
display shows “Delete Device #5.”
Enter 1 followed by # or NEXT.
Press EXIT to exit the programming menus and
save the changes.
Note: If the KF5 device # is not known, the complete list of bus
devices is viewable at option “Bus Device Type” in the “ST - Modl”
programming menu. All keyfobs are identied as bus device type 128.
Maintenance
Low Battery Indication
A low battery is indicated when the LED fails to blink
when a button is pressed.
Replacing the Battery
Remove the screw from the back of the Keyfob and
remove the cover.
Remove the old battery and dispose safely.
Insert the new battery (observe polarity + and – ).
Replace the cover and tighten screw.
Cleaning
Clean the KF5 with a cloth moistened with water and
a mild detergent. Do not submerge in water.
Troubleshooting
Problem Action
The panel does
not respond to
key presses.
Verify that the EXT is enrolled. This
can be done by checking option “EXT
Module” (60401) in the “ST - Modules”
menu in programming. If this option
is 0, the EXT is not recognized by the
system. Remove the EXT and see if a
trouble occurs. If not, replace the EXT.
Bring the KF5 closer to the EXT and
test again. If signals are properly
received, the issue may be related to
environmental noise or interference.
If the LED does not blink when a
button is pressed, replace the battery.
Distance from the receiver and
installation environment will affect
the sensor signal strength. Reposition
the EXT if necessary.
•
•
•
•
1.
2.
3.
4.
5.
6.
7.
1.
2.
3.
4.
Sequel Technologies
2958 Cleveland Ave. N
Roseville, MN 55113 USA
Copyright © 2008 Sequel Technologies, LLC.
2