User's Manual

5-Button Keyfob (KF
5
)
Installation Instructions
Sequel Technologies, LLC
General Description
The 5-Button Keyfob (KF5) is a multifunction keychain
transmitter compatible with the ST8 and ST Express
security systems. The KF5 provides a convenient way
to arm and disarm the system. It also includes the abil-
ity to activate a panic alarm and control X10 lights and
appliances (X10 PSC-04 Module required).
Additional Information:
User-replaceable lithium battery
Six functions: disarm, arm-perimeter, arm-all, light
control, panic alarm
Recessed buttons to minimize inadvertent activation
LED indicates signal transmission
Ability to control X10 lights and appliances
4
6
1
3
*
5
2
Figure 1: KF5 Layout
1: Arm All
Arms perimeter and interior burglary zones
2: LED
Blinks when a button is pressed
3: Disarm
Disarms the burglary portion of the system
and cancels alarms
4: Star Button
Reserved for future use
5: Arm Perimeter
Arms the perimeter burglary sensors
6: Lights
Toggles lights on/off
•
•
•
•
•
User Operation
To arm/disarm the system using the KF5:
Press the ARM PERIM button to arm the
system to the Arm Perimeter level.
Press the ARM ALL button to arm the system
to the Arm All level.
Press the DISARM button to disarm the
system.
Note: The system will automatically bypass open zones upon arm-
ing. The system will sound a short tone from the interior sounders
when the system is armed using the KF5.
To activate a panic alarm using the KF5:
Press and hold the ARM ALL and ARM
PERIMETER buttons simultaneously for three
seconds.
To turn lights on/off using the KF5 (requires X10
PSC-04 Module):
Press the LIGHTS button.
Programming
The following instructions provide a guideline for
enrolling the KF5 into system memory.
Enrolling the Keyfob
Enter program mode (NEXT + NEXT + NEXT +
<Prog> + Installer PIN)
The LCD keypad will display “Devices Available.”
Select <Learn>. The display shows “Auto Enroll On.”
To enroll the KF5, press ARM ALL and DISARM
simultaneously for three seconds.
Upon enrollment, the LCD keypad emits one beep and
the display shows the zone number and sensor ID.
Press <Done> on the LCD keypad to exit the
programming menu.
Note: The KF5 is viewed by the system as a bus device. A maximum
combination of 15 bus devices (LCD keypad, HWX, EIM, KF5) may
be enrolled into the system.
Configuring the Lights Button
Device 16 is the default X10 unit controlled by the
lights button. To change this setting see option “X-10
Output” in the “ST - InOu” programming menu.
•
•
•
•
•
1.
2.
3.
4.
5.
1