Data Sheet
Table Of Contents
- Datasheet
- Preface
- About this Datasheet
- Product Features
- Regulatory Approval
- Physical Characteristics
- 3.1 ECCN and Part Number
- 3.2 Electrical Operating Conditions
- 3.3 Environmental Operating Conditions
- 3.4 Auxiliary ADC Specification
- 3.5 Power Supply Dimensioning
- 3.6 I/O Characteristics
- 3.7 Package Description
- 3.8 Packing Information
- 3.9 Storage Conditions
- 3.10 Mounting Considerations
- 3.11 Component Reliability
- 3.12 RF Performance
- Signals and Pins
- Acronyms
REGULATORY APPROVAL
SP150Q DATASHEET PROPRIETARY 8
SEQUANS Communications
• Maximum Antenna Gain
The user instructions of end-products equipped with standard external
antenna connectors for the modular radio transmitter providing the option
to connect other antennae than those which may or may not be bundled
with the end-product must list the maximum allowed antenna gain values
as derived from those given above, accounting for the cable attenuations of
the actual installation.
• Digital Device - Unwanted Emissions Notice
If the end-product is or contains a digital device (unintentional radio
portions) and is not exempted by its use case (like vehicular use) the
following part 15.105 (b) user notice shall be provided at prominent loca-
tion of the product literature:
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
o Reorient or relocate the receiving antenna.
o Increase the separation between the equipment and receiver.
o Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
o Consult the dealer or an experienced radio/TV technician for help
• Further User Notices
May be required dependent on the FCC rule parts relevant to the host
product.
• Non-allowed User Instructions
The end-product user guidance may NOT include instructions about how
to install or de-install the module.