Data Sheet
Table Of Contents
- Datasheet
- Preface
- About this Datasheet
- Product Features
- Regulatory Approval
- Physical Characteristics
- 3.1 ECCN and Part Number
- 3.2 Electrical Operating Conditions
- 3.3 Environmental Operating Conditions
- 3.4 Auxiliary ADC Specification
- 3.5 Power Supply Dimensioning
- 3.6 I/O Characteristics
- 3.7 Package Description
- 3.8 Packing Information
- 3.9 Storage Conditions
- 3.10 Mounting Considerations
- 3.11 Component Reliability
- 3.12 RF Performance
- Signals and Pins
- Acronyms
REGULATORY APPROVAL
7 PROPRIETARY SP150Q DATASHEET
SEQUANS Communications
change to this modular approval or a separate host approval with different
FCC-ID;
Compliance with Unwanted Emission Limits for Digital Device
If the OEM host integration fully complies with the above described reference
design and can completely inherit and rest on compliance of the existing
modular approval the OEM remains still responsible to show compliance of
the overall end-product with the FCC limits for unwanted conducted and
radiated emissions from the digital device (unintentional radio) portion of
such end-product (commonly addressed as part 15B compliance or similar).
End-product Labelling
•FCC-ID
The module's FCC-ID must either be visible from the exterior of the host
product (e.g. per window) or per electronic display, or shall be displayed
on an additional exterior label per the following or similar string:
contains FCC-ID: 2AAGMSP150Q
• Digital Device - Unwanted Emissions Notice
If the end-product falls under part 15 of the FCC rules (it shall display the
following user notice on its exterior acc. to part 15.19 (the notice may be
printed in the manual in case the host is too small):
This device complies with Part 15 of the FCC Rules.Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference,
and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
• Further Labelling Requirements may apply dependent on the FCC rule
parts relevant to the host product.
• End-product User Instructions / Notices in the Manual
At a minimum, end-product users must be provided with the following
notices at a prominent location of the product literature furnished with the
product:
* Product Modifications
Modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this
equipment.
* RF Exposure Compliance
This equipment complies with FCC radio frequency radiation exposure
rules and limits set forth for an uncontrolled environment, when
installed and operated with minimum distance of 20cm between its
radiating structures (antenna) and the body of nearby persons and
when not operated simultaneously with other nearby
radio-transmitters.