User Manual

Confidential and Proprietary SEQUANS Communications 13
IMPORTANT NOTE: FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator &
your body.
This device is intended only for OEM integrators under the following
conditions:
The LM63S1 may transmit simultaneously with other collocated radio transmitters within a host device,
provided the following conditions are met:
1. Each collocated radio transmitter has been certified by FCC/IC for mobile application
2. At least 20 cm separation distance between the antennas of the collocated transmitters and the user’s
body must be maintained at all times
For mobile and fixed operating configurations the antenna gain, including cable loss, the device, module
LM63S1 must not exceed the following gain values per bands
- for B13 - 777-787
MHz , 6 dBi gain
- for B14 - 788-798 MHz , 6 dBi gain
- for B4 - 1710-1755 MHz, 6 dBi gain
The device (module LM63S1) can be co-located with WiFi device that transmit 17dBm with maximum peak
gain of 10dBi antenna.
As long as 2 conditions above are met, further transmitter test will not be required. However, the OEM
integrator is still responsible for testing their end-product for any additional compliance requirements
required with this module installed.
End Product Labeling
This transmitter module is authorized only for use in device where the antenna may be installed such
that 20 cm may be maintained between the antenna and users. The final end product must be labeled in
a visible area with the following: “Contains FCC ID: 2AAGMLM63S1”.
Manual Information To the End User
The OEM integrator has to be aware not to provide information to the end user regarding how to install
or remove this RF module in the user’s manual of the end product which integrates this module.