Data Sheet

REGULATORY APPROVAL
5 PROPRIETARY GM01Q DATASHEET
SEQUANS Communications
Compliance with Unwanted Emission Limits for Digital Device
If the OEM host integration fully complies with the above described reference
design and can completely inherit and rest on compliance of the existing
modular approval the OEM remains still responsible to show compliance of
the overall end-product with the FCC limits for unwanted conducted and
radiated emissions from the digital device (unintentional radio) portion of
such end-product (commonly addressed as part 15B compliance or similar).
End-product Labelling
•FCC-ID
The module's FCC-ID must either be visible from the exterior of the
host
product
(e.g. per window) or per electronic
display, or shall be displayed
on
an additional exterior label per the following or similar string:
contains FCC-ID: 2AAGMGM01Q
• Digital Device - Unwanted Emissions Notice
If the end-product falls under part 15 of the FCC rules (it
shall display the
following user
notice on its exterior acc. to part
15.19 (the notice may be
printed
in the manual in case the host is too small):
This device complies with Part 15 of the FCC Rules.Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference,
and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
• Further Labelling Requirements may apply dependent on the FCC rule
parts relevant
to the host product.
• End-product User Instructions / Notices in the Manual
At a minimum, end-product users must be provided with the following
notices at a prominent location of the product literature furnished with the
product:
* Product Modifications
Modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this
equipment.
* RF Exposure Compliance
This equipment complies with FCC radio frequency radiation exposure
rules and limits set forth for an uncontrolled environment, when
installed and operated with minimum distance of 20cm between its
radiating structures (antenna) and the body of nearby persons and
when not operated simultaneously with other nearby
radio-transmitters.
• Maximum Antenna Gain
The user instructions of end-produc
ts equipped with standard external
a
ntenna connectors for the modular radio transmitter providing the
option
to
connect other antennae than those which may or may not be bundle
d
with
the end-product must list the maximum allowed antenna gain values
as derived from those given above, accounting for the cable attenuations
of
the actual inst
allation.