User's Manual

PRELIMINARY DATA SHEET • SKY66430-11: LTE FOR IoT SYSTEM-in-PACKAGE
Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • [e-mail] • www.skyworksinc.com
24 August 26, 2019 • Skyworks Proprietary and Confidential Information • Products and Product Information are Subject to Change Without Notice • 204412F
FCC Regulatory Approval for the SKY66430-11
Note: This section applies to the SKY66430-11 part number only. The LTE Bands that are compliant with FCC are Band 2, Band 4, Band
12, Band 13, and Band 25.
Attention
SKY66430-11 FCC-ID: 2AAGM66430 (single modular approval)
This above identified LTE radio module is not intended to be provided to end users, but is for installation by OEM integrators only.
Installation/Integration
OEM integrators must follow SKY66430-11 installation instructions to provide for and benefit from FCC compliant module integrations and
must abide especially by the following:
The maximum antenna gain value (accounting for cable attenuation) to comply with the FCC maximum ERP/EIRP limits and with RF
Exposure rules is 2 dBi.
The SKY66430-11module integration guidelines must be closely followed.
Compliance of host integrations of the module is limited to hosts adaptation designs which are identical to SKY66430-11 reference
design.
Host integrations with adaption designs deviating from SKY66430-11 reference design require either class 2 permissive change to this
modular approval or a separate host approval with different FCC-ID.
Host integrations with co-located (simultaneously operating) radio transmitters must be evaluated in accordance with FCC multi-
transmitter rules and may require either class 2 permissive change to this modular approval or a separate host approval with different FCC-
ID, dependent on the result of the evaluation; Inquiry at FCC or a TCB is urgently recommended.
Integrations of the module into host products which are intended for portable use, i.e. less than 20 cm distance between its radiating
structures (antenna) and the body of nearby persons, or which otherwise put additional technical requirements like Hearing Aid
compatibility require either class 2 permissive change to this modular approval or a separate host approval with different FCC-ID.
Compliance with Unwanted Emission Limits for Digital Device
If the OEM host integration fully complies with the above described reference design and can completely inherit and rest on compliance of
the existing modular approval the OEM remains still responsible to show compliance of the overall end-product with the FCC limits for
unwanted conducted and radiated emissions from the digital device (unintentional radio) portion of such end-product (commonly
addressed as part 15B compliance or similar).
End-Product Labelling
 FCC-ID
The module's FCC-ID must either be visible from the exterior of the host product (e.g. per window) or per electronic display, or shall be
displayed on an additional exterior label per the following or similar string: contains FCC-ID: 2AAGM66430
 Digital Device - Unwanted Emissions Notice
If the end-product falls under part 15 of the FCC rules (it shall display the following user notice on its exterior acc. to part 15.19 (the
notice may be printed in the manual in case the host is too small):
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.