User's Manual

SKY66430-11 / SQN66430-11 SiP • Evaluation Board User Manual V1.0
Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • [e-mail] • www.skyworksinc.com
12 May 6, 2019 • Skyworks Proprietary Information • Products and Product Information are Subject to Change Without Notice • 205375A
7.3 DM Tool
This section is only informative in case you are invited to use DM Tool.
DM Tool is a Sequans proprietary tool, only needed for troubleshooting 3GPP protocols issues.
In general, all the operations on the evaluation board are to be run through AT Commands via serial terminal. DM Tool can allow
performing specific deep Monitoring and Debugging sessions.
When you are invited to use DM Tool, you need to have access to the following deliverables from your Sequans support.
 DM Tool Installation Program (sqn4gdm_setup_1.x-xxx.exe)
Basic DM documentations are embedded in the tool itself, through the help Menu.
 DM Tool Application Note Document
7.3.1 Connecting DM Tool to the Board
DM Tool has to be connected to UART 1, thus plug the mini-USB cable from your PC to the USB Port X of the board.
7.3.2 Using DM Tool
Read the DM Tool Application Note to configure and use the DM tool.