TDS

Page 4/10
Safety Data Sheet (SDS)
OSHA HazCom Standard 29 CFR 1910.1200(g) and GHS Rev 03.
Reviewed on 11/21/2017
Issue date 11/21/2017
Trade name: Natural Choices Oxy-Septic
46.0.6
·
Information about protection against explosions and fires:
No special measures required.
·
Conditions for safe storage, including any incompatibilities:
·
Storage
·
Requirements to be met by storerooms and receptacles:
Do not store in direct sunlight.
Keep away from heat sources and sunlight.
·
Information about storage in one common storage facility:
Not required.
·
Further information about storage conditions:
Keep container tightly sealed.
·
Specific end use(s):
No further relevant information available.
8 Exposure Controls/Personal Protection
·
Additional information about design of technical systems:
No further data; see section 7.
·
Control parameters:
·
Components with occupational exposure limits:
The produc
t does not contain any relevant quantities of materials with critical values that have to be monitored
at the workplace.
·
Additional information:
The lis
ts that were valid during the creation of this SDS were used as basis.
·
Exposure controls:
Pr
ovide general ventilation in processing and storage. Provide local exhaust if necessary to reduce dust
levels below acceptable limits.
·
Personal protective equipment:
·
General protective and hygienic measures:
Wash hands before breaks and at the end of work.
·
Breathing equipment:
NIOSH/MSHA approved breathing apparatus.
Not required.
·
Protection of hands:
Protective gloves
The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.
Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/
the chemical mixture.
Select glove material based on penetration times, rates of diffusion and degradation.
·
M
aterial of gloves:
The selection of the suitable gloves does not only depend on the material, but also on further marks of quality
and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the
resistance of the glove material cannot be calculated in advance and has therefore to be checked prior to the
application.
Not applicable.
·
Penetration time of glove material:
The
exact break-through time has to be determined and observed by the manufacturer of the protective
gloves.
(Contd. on page 5)