Datasheet

www.seoulsemicon.com

Product Data Sheet

 “제품 명 – 제품 군” 을 기입하십시오.

제품 군은 홈페이지 응용분야 분류기준을 참고한다.

(예) SZ5M0WWC9 – High-power LED

Font 글씨체

표(Table) - 제목: Arial 10pt, 표 내부: Arial 8pt, 본문(Body) – Arial 9pt

 Revision numbering 기준:

• 가스펙은 0.0 부터 시작 0.x….

• Final 승인원: 1.0 부터 시작

• 기존에서 일부 수정: +0.1

• 새로운 Data 추가 /또는 기존 것 삭제: +1.0

 수정일자 표기형식; YYYY-MM-DD

(예) 2013-04-01

MJT 5630-Acrich MJT

Handling of Silicone Resin for LEDs

(1) During processing, mechanical stress on the surface should be minimized as much as possible. Sharp objects

of all types should not be used to pierce the sealing compound.

(2) In general, LEDs should only be handled from the side. By the way, this also applies to LEDs without a silicone

sealant, since the surface can also become scratched.

(3) When populating boards in SMT production, there are basically no restrictions regarding the form of the pick

and place nozzle, except that mechanical pressure on the surface of the resin must be prevented.

This is assured by choosing a pick and place nozzle which is larger than the LED’s reflector area.

(4) Silicone differs from materials conventionally used for the manufacturing of LEDs. These conditions must be

considered during the handling of such devices. Compared to standard encapsulants, silicone is generally softer,

and the surface is more likely to attract dust.

As mentioned previously, the increased sensitivity to dust requires special care

during processing. In cases where a minimal level of dirt and dust particles cannot be guaranteed, a suitable

cleaning solution must be applied to the surface after the soldering of components.

(5) SSC suggests using isopropyl alcohol for cleaning. In case other solvents are used, it must be assured that

these solvents do not dissolve the package or resin.

Ultrasonic cleaning is not recommended. Ultrasonic cleaning may cause damage to the LED.

(6) Please do not mold this product into another resin (epoxy, urethane, etc) and do not handle this product with

acid or sulfur material in sealed space.

(7) Avoid leaving fingerprints on silicone resin parts.