User`s manual

9
AKR-301 Full Manual V.1.5
Chapter 4: Getting Started
OVERVIEW ON SET-UP PROCEDURES
Below is an overview of the installation steps required get your AKR-301 unit working.
Each step is explained in detail in Chapter 5 - Hardware Installation.
(1) Insert a SD MEMORY.
(2) Connect the AKR-301 to a TV set or monitor by using AV-OUT cable.
(3) Connect the power.
(4) Turn the power on.
(5) Start TV Monitoring and recording.
General Operating Advice:
● Make sure that a SD Memory card is inserted.
(See Chapter 5 -Hardware Installation)
● The firmware used in AKR-301 is compatible with your computer’s operating system (i.e. Windows).
Therefore, you can take the SD memory card from this AKR-301 and install it in your computer to view
recorded video. (Refer to the AKR Player manual.)
● AKR-301 offers you the flexibility to choose a recording frame rate (maximum rate: 30 frames per second).
The faster frame rate the greater the SD Memory storage capacity required. Reducing the frame rate
(minimum rate: 1 frame per 10 seconds) will allow a greater recording duration.
● When first powering up AKR-301, the unit enters the default operational state: “VIEW mode”.
In this mode, AKR-301 does not record nor play the recorded stream, but only shows the current images from
the camera.
● The default recording values for the AKR-301 are 30 frames per second (25 frames in PAL) with normal
video quality. If you use 1GB SD Memory, AKR-301 can record for approximately 2 hours.
● If the power is inappropriately turned off while AKR-301 is in the record mode (i.e. power failure), it will re-
enter the record mode automatically when power is re-established.
Refer to Chapter 5 - Hardware Installation for more information on installation procedures.