User`s manual

11
AKR-100 Full Manual V.1.5
To display images from the AKR-100, connect the video output signal to your monitor or Television. Any
Television with a VIDEO INPUT terminal is suitable for displaying the images. The diagram above shows
the video signal connections.
Connect the camera to VIDEO-IN terminal of AV-IN connector; connect the monitor to VIDEO OUT
terminal of AV-OUT connector.
Note: The RCA cable required for this connection is not included in the package of AKR-100.
② Audio Input/Output Connection (For TV / monitor speaker)
Connect the microphone to AUDIO-IN terminal of AV-IN connector; connect the speaker to AUDIO OUT
terminal of AV-OUT connector.
Note: The RCA cable required for this connection does not come packaged with the AKR-100.
ALARM INSTALLATION
The AKR-100 has an internal switch for sounding an alarm. When a sensor is triggered, the alarm is
activated as well.
There are two steps to install an alarm.
1. Connect the alarm power lines to the alarm switch terminal.
2. Connect the alarm power lines to the appropriate power source.
Refer to the diagram below for information on how to connect an alarm to your AKR-100.