Operating instructions

1Channel Video Server SVG-3110 Full Manual
29
3.3. Installation with a Router
3.3.1. Network Setup with a Router
1) After checking Video, connect SVG-3110 to a PC with a Cross LAN Cable
2) Cable connection and Network Setup should be done as shown in ‘ 2.1. Installation and
2.2 network setting ’.
3) Go to ‘Network Setting’
4) Input default IP Address, Subnet Mask, Gateway of SVG-3110.
5) Input first and secondary IP addresses for DNS. In a case like this SVG-3110 is installed
with an IP Sharing Device, type the local IP of the Router in the 2
nd
DNS Address.
6) Setup Port numbers in the each line of Port Setting.
7) Click ‘Apply’ to save setting values.
8) After network setting, remove a Cross LAN connected between SVG-3110 and a PC.
9) Connect SVG-3110 to the Router with a Straight LAN Cable.
10) Connect a PC to the Router with a Straight LAN Cable.
11) Forward ports in the router to match the port setting of SVG-3110. Refer to the manual
of the router for details.
12) Checkup the network connection:
Run a Web Browser and input IP address of SVG-3110 in URL and click ‘Enter’. The
user can change the HTTP port number, if necessary. In this case, you need to
additionally input the new port number in URL: ‘http://IP Address:Port Number’.
For example, if you assign the IP address of SVG-3110 to 192.168.1.10 and change the
HTTP port number from 80 to 81, you must input Http://192.168.1.10:81.
13) Check Video of SVG-3110 referring to ‘3.2.1. VIDEO CHECK’ as soon as the server has a
network connection with the IP newly set up.