User`s guide

Wiring the DVR
All TR9 wiring harnesses plug into connectors on the termination panel of the docking
tray. The termination panel must be removed from the docking tray to connect the
wiring harnesses. Follow the instructions on page 7 of this manual to remove the
termination panel and to install the cable grommet and hole plug in the docking tray
access holes.
NOTE: Audio input jacks 1 and 2 are connected in parallel with the audio inputs of
cameras 1 and 2, respectively. If you connect remote microphones to the audio input
jacks, the audio signals from the camera harness must be disconnected inside the
camera. See the
Camera Harness section of this manual on page 9 for details.
The wiring harnesses enter the docking tray through one of the cable access holes.
Leave enough slack in the cables to allow the termination panel to be removed with the
harnesses attached.
The wiring harnesses can be surface mounted or concealed. If a harness is surface
mounted, ensure that it is secured at frequent points and protected from sharp corners.
If a harness is concealed, pull it from the un-terminated end to minimize the size
requirements of conduits and access holes.
The standard wiring harness length is 20 feet (6m) long. Please contact Seon Design if
you need a longer harness.
8