User`s guide

Installation
2–6 700-0035 R004
2.4. Step 3: Installing the Camera
If you have purchased a camera from Seon Design, install the camera according to
the documentation that shipped with the product.
To connect the camera (and the optional external microphone) to the DVR:
1. Plug the 6-pin mini-DIN connector from the camera into the mating connector
on the back of the DVR. See Figure 2-3.
2. If an optional external microphone is being used, plug the power connection
into either
AUX POWER 1 or AUX POWER 2. Plug the RCA connector into the
AUDIO IN 1 or AUDIO IN 2 jack. See “Checking the Camera Cable
Connections” on page 2–6 about disconnecting the audio from a camera when
using the external microphone.
If you have a camera already installed, see “Checking the Camera Cable
Connections”.
2.4.1. Checking the Camera Cable Connections
The TR4 Plus System uses an integrated mini-DIN connector for the camera
signal. The cable comes prewired into the camera, but in the event that the cable
becomes disconnected, reattach into the terminal blocks inside the camera as
shown in Figure 2-4. The cable colors for correct wiring to the terminals are
described in Table 2-2. For complete camera information, see the product insert
for the camera (for example, SA Series Wedge Camera Setup Guide document part
number 700-0004).
7 LAN Ethernet LAN connector
8
VIDEO OUT Video output jack: Yellow RCA style
9
AUDIO IN 1, 2
AUDIO OUT 1, 2
Audio input jacks: White RCA style
Audio output jacks: Red RCA style
10
AUX POWER 1, 2 Auxiliary Power jacks: 2.1 mm barrels or 2-pin connector
11
VIDEO OUT Camera input connectors: 4 × 6-pin mini-DIN
12 FAN Fan with filter and removable cover
Table 2-1 Back panel features
Item Feature Description