User`s guide

The Trooper™ Basic Installation and User’s Guide 4
3. Installing the DVR
3.1 Installing with the SCT-LD Enclosure
The Trooper™ TR4-10 DVR has two brackets attached to the sides that
allow it to slide easily in and out of the enclosure. The brackets also enable
easy ‘top-up’ orientation of the DVR when installed on the floor or under a
seat.
The rear of each bracket has two plastic retainers that allow cables to easily
slip in between to ensure they do not get pinched at the back of the enclosure
when the DVR slides in.
3.2 Description of DVR Connectors
The front of the DVR has a standard RCA-style Video Output Jack used
during setup and playback. There is also a special red Temporary Power
Button that will provide power to the DVR independently of the vehicle
ignition.
On the back of The Trooper™ TR4-10 DVR are the connectors for the
camera inputs, audio inputs and power output for an optional remote
microphone or remote infrared module, a video and audio output for playback,
the Power Input Harness, and the Alarm Input Cable.
Cable Retainers
Temporary Power Switch
Video Output Jack