User`s guide

The Trooper™ Basic Installation and User’s Guide 2
Installation
1. Horizontal Installation
The Trooper™ Lock Box can be mounted on the floor, or underneath a seat.
There are four mounting points in the base of the enclosure that stand the unit off
the mounting surface by 3/16”.
a. Unlock the door and remove it from the enclosure base. Slide the DVR out of
the enclosure by pulling on the two bracket tabs at the front of the DVR.
b. Detach the lid from the enclosure base by removing the 2 retaining screws on
the sides of the lid near the front of the enclosure.
c. Decide whether the power and camera cables will enter the enclosure on the
LEFT or RIGHT side. Swap the Cable Grommet and the Hole Plug if required.
d. Use the 4 enclosed #10 x ¾” screws or #10 x 1” self-drilling screws to secure
the enclosure base to the floor.
If mounting under a seat, please call your Seon Design™ sales
representative or dealer to inquire about the special Underseat Mounting
Bracket Kit available.
e. Slide the lid on to the enclosure and secure it with the 2 retaining screws
removed earlier.
Hole Plug
Cable Grommet