User`s guide

The Trooper™ Basic Installation and User’s Guide 25
Searching by the ALARM LIST allows the user to quickly identify any
problems that the driver may have indicated by pressing the Alarm Input
Switch (see the Installation Section 6 and the Operation Section 3.8 for more
information on the Alarm Input).
An example of a list of Alarm
Events is shown in the picture at
the left.
After the Alarm number, the type of alarm is indicated. An external Alarm
Input is indicated as ‘A1’. If the DVR did not detect a video input for a specific
camera, the then ‘V1’, ‘V2’, ‘V3’, or ‘V4’ would be displayed. If all of the video
signals were disconnected, the ‘VA’ would be displayed. If the power were
disconnected while the DVR was recording, then ‘PL’ would be displayed.
Use the center JOG Wheel to scroll through different pages of alarm events.
Pressing the ‘ENTER’ button when an Alarm event has been chosen will
make the DVR will start playing from that time. If the chosen alarm event was
a Video Loss (V1) or Power Loss (PL), then the DVR will start playing
immediately after the video or power returned. Pressing the ‘REV.PLAY’
button will play backwards to the time before the event occurred.
Searching by Time and Date is straightforward.
Choose the desired time and
date by using the ‘UP’ and
‘DOWN’ arrow buttons to
change a field. Use the ‘LEFT’
and ‘RIGHT’ arrow buttons to
move between fields.
When the desired time and date
are selected, use the ‘LEFT’ or
‘RIGHT’ button to choose
‘SEARCH’ and press the
‘ENTER’ button. The DVR will
start the playing from the chosen
time.
ALARM SEARCH
0001 A1 05/11/2004 04:42:23PM
0002 A1 05/11/2004 04:46:37PM
0003 V1 05/12/2004 08:17:44AM
0004 PL 05/12/2004 08:21:18AM
DATE/TIME SEARCH
MM/DD/YYYY HH:MM:SS
05/11/2004 04:42:23 PM SEARCH