User`s guide

The Trooper™ Basic Installation and User’s Guide 23
Pressing the ‘DISPLAY’ button
will show the information in the
picture to the left.
‘DISK’ is the formatted size of
the installed hard-drive,
measured in Gigabytes.
‘OPER’ is the current operation
of the DVR; in this case it is
recording.
‘R. POS’ (Record Position)
shows how much of the hard-
drive has been recorded.
‘SPEED’ is the current recording speed, displayed in images per second.
Pressing the ‘DISPLAY’ button again will turn off all of the on-screen
information. Pressing the ‘DISPLAY’ button once more returns to the first
screen shown above.
Pressing the ‘DISPLAY’ button when the DVR has stopped recording will
show similar information on the screen as during recording, except that the
‘OPER’ parameter will be changed to ‘LIVE’
Pressing the ‘DISPLAY’ button when the DVR is playing will, again, show
similar information on the screen, except that the ‘OPER’ message will be
changed to ‘PLAY’.
5.16 REC Button
Pressing the ‘REC’ button will start the DVR recording if the DVR is not
playing video or in the menus.
5.17 REV.PLAY Button
During playback, or when stopped, pressing the ‘REV.PLAY’ button will start
playing the video in reverse.
5.18 STOP Button
The ‘STOP’ button stops the DVR from recording or playing. If the DVR is
recording, pressing the ‘STOP’ button will allow about 5 seconds before the
DVR starts recording again. During this time, the user can enter the menu
system, start to play back video, or copy video to the Compact Flash memory
card.
5.19 PLAY Button
If the DVR is not recording, pressing ‘PLAY’ will start to play the recorded
video and audio. See also Section 5.23 below on the ‘SHUTTLE/JOG’ wheel.
5.20 PAUSE Button
This button will pause the video playback and provide a still frame video
image. See also Section 5.23 below on the ‘SHUTTLE/JOG’ wheel.
CAMERA 1
DISK : 39GB
OPER : REC
R. POS: 39.2%
SPEED : 15 IPS
SCHOOL BUS
12.6V 05/11/2004 09:34:56 AM