User`s guide

The Trooper™ Basic Installation and User’s Guide 22
5.11 Channel Buttons
The four camera channel buttons (CH1, CH2, CH3, and CH4) change which
camera is displayed on the monitor. If a camera channel button is pressed,
but there is no camera plugged in, then a blue screen will be displayed.
5.12 MODE Button
The MODE button changes the way the cameras are displayed on the
monitor. Pressing the MODE button will change the display from ‘quad’ mode
(all four cameras displayed) to PIP (picture-in-picture) mode. When displaying
in PIP mode, press the camera channel buttons to change which camera is
the ‘large’ image and which is the ‘small’, PIP image.
When in ‘quad’ mode, press any of the camera channel buttons to see that
image full screen.
5.13 ZOOM Button
During recording and playback, press the ZOOM button to magnify the image
on the screen 2x. Use the UP, DOWN, LEFT, and RIGHT buttons to move
around the image on the screen.
Press the ZOOM button again to exit ZOOM mode.
5.14 SEQ Button
When recording or playing back, pressing the SEQ button will cycle the
display between ‘quad’ image mode and individual camera views. The cycle
time for each view is 3 seconds.
Press the SEQ button again to exit this mode.
5.15 DISPLAY Button
While the DVR is recording, different information can be displayed on the
screen. The default is to show the time, date, main title, camera title, and
voltage. See the picture below:
CAMERA 1
SCHOOL BUS
12.6V 05/11/2004 09:34:56 AM