User`s guide

The Trooper™ Basic Installation and User’s Guide 20
5. DVR Operation
The DVR controls are similar in function to VCR controls. Because of the extra
functionality, there are added controls specifically for use with the DVR.
5.1 Temporary Power Button
The Temporary Power Button on the front of the DVR has several functions.
When the vehicle ignition is turned off, pressing the button for 3 seconds will
power up the DVR, but not initiate recording. This allows the user time to
change program settings or playback short video clips.
If the vehicle ignition is turned on, then the Temporary Power button can be
used to bypass the Delay-On time. Simply press the button during the Delay-
On interval for 5 seconds and the DVR will power up and start recording.
During the Delay-Off interval, pressing the Temporary Power Button for 5
seconds will bypass the Delay-Off time and shut off the DVR immediately.
5.2 Video Output Jack
The yellow Video Output Jack on the front of the DVR is used during setup
and playback. The connector has the same function as the Video Output
Jacks on the back of the DVR. Note that only one device at a time can be
connected to the Video Output Jacks.
5.3 Compact Flash Card Slot
The Trooper™ TR4-10 DVR can save video and audio information onto a
removable Compact Flash memory card (CF Card), as well as receive
program updates from the CF Card. The CF Card can only be inserted into
Video Output Jack
Temporary
Power Button
Compact Flash
Card Slot
Hard-Drive Lock
Removable Hard-Drive
IR Remote Control
Receiver
Alarm Event
Indicator
DVR Power
Indicator
Hard-Drive Power
Indicator
Hard-Drive Access
Indicator
SHUTTLE Wheel
JOG Wheel (Center)