User`s guide

The Trooper™ Basic Installation and User’s Guide 14

MIN’, ‘4 MIN’, ‘5 MIN’, ’10 MIN’, ’15 MIN’, ’20 MIN’, ’30 MIN’, ’45 MIN’, and ’60

MIN’.

Note that after power-up, the DVR may take up to 20 seconds to start

recording as it performs a thorough self-test.

3.6 Delay-Off Time

The Delay-Off option enables the DVR to continue recording after the driver

has turned off the vehicle ignition. Several different times are available: 15

seconds, 30 seconds, 1 minute, 2 minutes, 3 minutes, 4 minutes, 5 minutes,

10 minutes, 15 minutes, 30 minutes, 45 minutes, and 60 minutes. Choosing

‘0’ will disable the Delay-Off feature.

3.7 Timers

The Trooper™ Basic DVR has the ability to record at preset times during the

day. This is helpful when a bus may have a long drive before picking up any

passengers. Choosing the Timers option brings up the following menu:

The default setting for the

timers is ‘OFF’. When

turned ‘ON’, the DVR will

not record unless a timer

has been turned on.

The default setting for each

individual timer is also

‘OFF’. When turning ‘ON’ a

timer it is very important

that it be programmed

correctly.

The ‘Day’ of each timer can be set to a particular day of the week (SUN,

MON, TUE, WED, THU, FRI, and SAT), or it can be set to record every

Weekday (WDAY), only on the Weekend (WEND), or every day (DLY). The

‘Start’ and ‘Stop’ times are displayed in the 24-hour mode.

The Record Speed and Picture Quality can also be set differently for each

Timer interval. Refer to Sections 3.1 and 3.2 above for more information on

Speed and Picture Quality, respectively.

The vehicle ignition must be turned on for the timers to work. Try to avoid

overlapping timer Start and Stop times as they can appear confusing. Also

note that the Delay-On settings are over-ridden by the timers, except for the

first 30 seconds. If the system is recording during a Timer interval, then the

Delay-Off settings will over-ride the timer once the vehicle ignition is turned

off.

NOTE: If the Timers are enabled (‘ON’) and all the individual timers are ‘OFF’

then the DVR will never start recording. Either turn on an individual timer, or

set Enable Timers to ‘OFF’.

TIMERS

ENABLE TIMERS: OFF

DAY START STOP SPEED QUALITY SET

SUN 12:00A 12:00A 10 IPS 4 OFF