User`s guide

The Trooper™ Basic Installation and User’s Guide 6
4. Camera Cable
The 4-Channel Trooper™ System uses an integrated Mini-DIN connector for all
of the camera signals. The cable comes pre-wired into the camera, but if
disconnected, it is easily re-attached into the terminal blocks inside the camera.
The color chart below describes each wire:
Cable Colors Description
Red Power Positive (+)
Black (and Silver) Power Ground (-)
Green Audio Positive (+)
White Audio Ground (-)
Yellow Video Positive (+)
Blue or Brown Video Ground (-)
The wires attach to the terminal blocks in the camera as shown below:
The Camera Cable is 20 feet long and should be long enough to reach from a
camera mounted to the header or ceiling of a bus down to the DVR Lock Box.
Longer cables can be obtained by contacting Seon Design™.
The cable can be surface run or concealed. If the installation is surface run,
ensure that the cable is secured at multiple points and is protected from sharp
corners.
If the cable is concealed, then it can be pulled from either end. Pulling from the
connector end will require larger holes in panels; pulling from the wire end will
require the cable to be disconnected from the camera.
The cable enters the DVR Lock Box through the large cable grommet near the
door. The connectors can be fed through the grommet one at a time, or the
grommet can be cut at the top and the cables can be simply slid into the
grommet. Leave enough cable in the DVR Lock Box to allow the DVR to slide all
the way back.
Red Wire
- Power Positive (+)
Black Wire
- Power Ground (-)
Green Wire
- Audio Positive (+)
- Disconnect on Camera 1 or Camera 2 if
using a remote microphone
White Wire
- Audio Ground (-)
- Disconnect on Camera 1 or Camera 2 if
using a remote microphone
Blue or Brown Wire
- Video Ground (-)
Yellow Wire
- Video Positive (+)