User guide

Introduction

700-0098 R006 1–5

1.5.2. DVR Back Panel Features

The TL4 DVR back panel is shown in the following figure and described in the

following table. The TL2 DVR has two camera connectors.

VIDEO OUT

(yellow)

RCA jack for DVR configuration, troubleshooting, video playback, live viewing with

portable monitor and mouse.

8 ONE TOUCH

(gray button)

Press to start one-touch downloading to portable media installed in the USB port.

See Using One-Touch Download, on page 2–12.

9 STOP/TEMP PWR

(red button)

• Power on the DVR for five minutes if held for more than 5 seconds.

• Powers down the DVR if held for more than 5 seconds when the DVR is in temporary

power mode, or in shutdown sequence and the ignition is off.

• Press the STOP button to stop the DVR from recording or playing.

Table 1-1

Front Panel Features

Item Feature Description

Figure 1-3

TL4 DVR Back Panel Connectors

Table 1-2

Back Panel Features

Item Feature Description

1 ALARM Alarm input connector for the alarm button.

2 CONTROL Control connector for the Smart-Reach® Mobile wireless bridge equipment.

3 Camera 1 to camera 4 Four camera input connectors.

4 Fan Intake fan with filter and removable cover. See Chapter Chapter 5, “Maintenance and

Service”.

5 VIDEO OUT Video output for viewing video; BNC connector.

6 GPS GPS receiver connector.

7 SIGNALS Connector for adapter harness. The speed harness and signal harness connect to the adapter

harness. (The alarm and diagnostic indicator/alarm button connections are optional.)

8 POWER Power input connector for connecting the power harness.

9 ETHERNET Ethernet port with RJ-45 connector for connecting to the LAN. Ethernet is used to connect

either to a PC or directly to the Smart-Reach wireless bridge or other equipment.