User guide

DVR Firmware and Configuration Uploads
4–2 700-0098 R006
4.1. Firmware Updates
The firmware version is displayed on the top right corner of every menu. The
firmware update must be obtained from Seon Design.
To install a firmware update, a USB memory device must be formatted by a
Windows®-based computer using the FAT file format.
Load the Program Update file onto the USB memory device.
To install a firmware update on the TL:
1. Power up the DVR using the vehicle ignition.
2. Insert the USB memory device with the new firmware version into the USB port
on the DVR.
3. After the DVR has started, go to the System Settings menu > Program Update >
Update.
A window appears asking if you wish to update the DVR firmware.
4. Click Yes to proceed or No to cancel.
Clicking Yes starts the firmware update, and the progress bar shows the percent
complete of the upgrade.
5. Once the update is finished, the DVR will automatically restart.
6. Remove the USB memory device.
CAUTION: Equipment damage
Do not use temporary power mode to power up the DVR for a firmware update.
Do not remove switched and constant power while updating the DVR firmware.
Figure 4-1 Updating DVR Firmware Dialog Box
Important: On restarting, the DVR will take up to 3 minutes to load as it completes the upgrade
process. Wait until the DVR finishes loading.