User guide

Installation
700-0099 R008 1–3
1.3.1. TL4 Installation Diagram
Figure 1 Typical TL4 System
Explorer® TL4
Typical System Setup
Vehicle Electrical Interface
Peripherals
Seon System
Supports Four Cameras
GPS Receiver
*1
Adapter
Harness
*2
Red - Not used
Green - Speed sensor high
Black - Speed sensor low
3 wires
SPEED
Alarm Switch
*1 For speed tracking, use a GPS receiver or speed harness. For ease of installation and better speed tracking, Seon recommends using a GPS receiver.
*2 The Diagnostic Button and alarm input harness are optional and require the adapter harness.
*3 An optional Smart-Reach Cellular, Smart-Reach Lite (Wi-Fi), or Laptop can be used from the Ethernet input located on the back panel.
*4 An optional Video Monitor can be used from the video outputs located on the front or back panel.
Portable Video Monitor *
4
Diagnostic Button
Optional Accessories
To DVR GPS Input
To DVR
ALARM
Input
To DVR
Camera
Inputs
To DVR
POWER
Input
To DVR SIGNALS Input
Laptop *
3
To DVR VIDEO OUT
TL4 DVR Rear Panel
To
Adapter
Harness
DIAGNOSTIC
Input
To DVR
ETHERNET
Input
Smart-Reach Lite
(Wi-Fi)*
3
Smart-Reach Cellular
Modem*
3
1x5 Microfit
DIAGNOSTIC BUTTON
Black - Left Turn
Green - Stop
Red - Brake Signal
Brown - Warning
White - Right Turn
5 wires
SIGNALS
Red - Vehicle + 12V
5A
3 wires
Yellow - Vehicle Switched + 12V
Black - Battery Negative
POWER
1A