User guide

DVR Setup
2–12 700-0099 R008
19. In the Configuration menu, click System and in System Settings menu, configure as
follows.
20. In the System Settings menus click Program Update and in the Program Update
menu, store the DVR configuration as a file to upload to other DVRs.
Disk Full, HD Failure: Leave Off
unless your network is configured to
receive emails from the DVR.
Password Enable: Leave Off
unless instructed otherwise.
Audio Output Channel: Select the
default audio channel that will be
available from the audio RCA port
on the front of the DVR.
vMax Web Timeout: Leave at default 10 minutes.
Click Back to save the menu settings.
Figure 2-18 System Settings Menu
Select USB Device as the file
saving destination. Plug a USB
memory device into the front of the
DVR. Click Store to save the file on
the USB memory device.
Load: For details on uploading
configurations to the DVR, see
DVR Menu Access, on page 2–1
.
Update: Firmware updates can also
be delivered by a USB device. The
DVR will reboot when done.
Format: Format the hard drive when the configuration is complete and before
final delivery of the installation to the customer.
Click Back to save the menu settings.
Figure 2-19 Program Update Menu