User guide

DVR Setup
700-0099 R008 2–9
14. In the Alarms and Signals menu, click Signals.
The DVR signal harness has 5 dedicated signal input wire connections:
• LT - black wire
• STP - green wire
• BRK - red wire
• WRN - brown wire
• RT - white wire
15. In the Alarms and Signals menu, click Speed.
Label: For signals 1-5, labels are
provided for left turn, stop, brake,
warning light, and right turn. The
labels can be edited and changed,
maximum 3 characters.
Level: Set all signal levels as
required. Choose Active High if the
circuit you are installing into rests at
0 VDC and goes to 12 VDC when
active. Choose Active Low if the
circuit rests at 12 VDC and drops to
0 VDC when active.
Alarm: Select the alarm number if the signal is also to be used to trigger an
alarm. That alarm’s input must also be set up in the Alarms menu.
Click Back to save the menu settings.
Figure 2-13 Signals 1 to 5 Menu
Speed Display : Select speed input
type (GPS or Pulse).
If GPS is
installed, select GPS.
Speed Units : Choose MPH for US
or KPH for Canada.
Speed Pulse Count: Displayed if
Pulse is selected from Speed
Display. Click Calibrate to set the
Pulse speed sensor if Pulse is
selected from Speed Display.
Speed Limit : Enter the speed limit which will trigger the excessive speed alarm
when exceeded.
Excessive Speed Action : Select the alarm which will be triggered by excessive
speed.
Click Back to save the menu settings.
Figure 2-14 Speed Settings Menu