User guide

Installation
1–8 700-0099 R008
6. Fasten the mounting plate to the mounting surface with the four #10 × ¾ sheet
metal screws or #10 × 1" self-drilling screws. See Figure 1-3
.
7. Clip the tray spring tab to the notch in the bottom back edge of the DVR.
8. Fasten the flange to the front of the DVR with the two pan-head Phillips 3/16"
screws.
9. Connect the necessary cables and components.
1.6.2. Camera Installation
Install the cameras according to the product documentation that is included with the
camera.
Feed the cable through the large cable grommets one at a time, or cut a space from the
edge of the cable cover to the grommet and slide the cables into the grommet.
Figure 1-3 DVR Attaching to Mounting Plate
6
6
6
7
6
8
8
66
CAUTION: Wiring Damage
Route the wiring and cables away from sharp edges that might damage
the insulation. Avoid sharp bends in the cable.