Specifications

Installation and Quick Configuration Guide
700-0077 R002 7
Camera Installation
Install the cameras according to the documentation that shipped with the product.
Feed the cable through one of the large cable grommets one at a time, or cut the grommet at the top and slide the cables into the grommet.
MX4 Basic: Alarm Button Installation
To install the alarm button:
1 Mount the alarm button into a ½" hole, and attach to the alarm input harness using the butt spice connectors.
2 Attach the black wire of the alarm button to the black wire of the alarm input harness.
3 Attach the blue wire of the alarm button to the red wire in the alarm input harness.
4 Connect the alarm input connector to
ALARM INPUT on the DVR.
MX4 Plus: Smart-Link™ Installation
To mount the Smart-Link:
1 Mount the Smart-Link using the four #10 × ¾" sheet metal screws or the four #10 × ¾" self-drilling screws. See Figure 5.
CAUTION
Route the wiring and cables away from sharp edges that might damage the insulation. Avoid sharp bends in the cable.
Figure 4 Alarm Button and Alarm Input Harness
Important:
• Choose a dry location with easy access to the electrical panel and cable connections to mount the Smart-Link.
• Always use the supplied fuses to provide over-current protection on the system wiring. The harness kit includes two fuses for the two 12V lines
required to complete this installation.