Setup guide

Explorer MX-HD Install and Setup Guide
700-0159 R003 59
Network Settings Menu
The Explorer MX-HD DVR has a built-in Ethernet interface for connecting to any of the following:
• HD camera for high definition recording
• PC computer with IE 8 for vMax Web DVR access
• Smart-Reach
®
mobile wireless bridge equipment (analog cameras only)
See Installation Diagrams
, on page 5.
Use the Network settings menu to set the network communication parameters necessary to use the Smart-
Reach Mobile wireless bridge equipment and Ethernet on the Explorer MX-HD.
CAUTION: Network Configuration
To connect using the network connection, each host (computer) connected to the network must
have a unique IP address. A qualified IT administrator is required to provide information
about the network settings and to configure the Network settings, DDNS settings, and E-mail
settings.
To perform any configuration, assign an IP address, reset the Smart-Reach Mobile wireless
bridge, or other operating information, contact Seon Technical Support.
Figure 76 Network Settings Menu
Table 19 Network Settings Configuration Items
Menu Item Description Value [Default]
Setting Type For network settings, consult your IT administrator to
configure the setting type and IP address.
If DHCP is used, the subnet mask, default gateway and DNS
server are configured automatically.
Off,
[Static IP], (a permanent address on
the Internet assigned by the
network administrator),
DHCP (Dynamic Host
Configuration Protocol) automates
the assignment of IP addresses in a
network
IP Address Uses an IP address composed of four octets separated by
decimals.
[169.254.1.1]
Subnet Mask Enter the network subnet mask as determined by a qualified
network expert.
[255.255.0.0]