Setup guide

Explorer MX-HD Install and Setup Guide
58 700-0159 R003
Advanced Settings Menu
The Advanced Settings menu is used to change the IP subnet address that the DVR monitors to receive HD
camera data. These IP settings should only be changed if the HD camera subnet conflicts with the DVR
network subnet. If the IP address in this menu is edited, the IP address stored on the camera must be
similarly changed.
CAUTION: HD Camera Network
Contact Seon Support if you wish to edit settings on this menu. Improper editing may cause network
communication problems.
Important: In order for the DVR to communicate with other network equipment, the IP Addresses, Subnet Mask, and HTTP
port must be set correctly. If not set correctly, communication failure including loss of recording will result.
Tip: Contact Customer Service for help performing any additional configurations such as changing the HD Camera Advanced
settings.
Figure 75 Advanced HD Camera Settings Menu
Table 18 Timer Settings 1 to 10)
Menu Item Description Value [Default]
DVR Camera-Net IP
Address
Enter the DVR’s subnet IP address for communicating with the
attached HD camera.
[172.30.1.100]
Maximum 12 characters
Mask
Enter a subnet mask, (12 characters maximum). The DVR uses
the Mask to auto-complete the common segments of the HD
Camera IP Address.
[255.255.255.0]
HD Camera IP Address Enter the attached HD camera’s subnet IP address (12 characters
maximum).
[172.30.1.1]
HTTP Port Enter an HTTP port. [80], 1025 to 65535
HD Cam Defaults Click to reload the default settings for the IP addresses, subnet
mask, and HTTP port, and the HD Camera menu settings.
See Figure 75
Test Camera Connection Click to test camera connection. Green = working
Red = not working.