Setup guide

Explorer MX-HD Install and Setup Guide
700-0159 R003 53
* The Geo-fencing rectangular area is defined by the top left and bottom right coordinates. If other
coordinates are entered, such as top right and bottom left, inaccurate results may be generated.
Recording Settings Menu
Use the Recording Settings menu to set the resolution, camera speed in frames per second (FPS), image
quality, Record Delay-On and Record Delay-Off times, and other recording options.
Bottom Right: LAT * Set the latitude to 0° 00.00.00’ through 90° 00.00.00’. [0 0.0 0 N]
Bottom Right: LONG * Set the longitude to 0° 00.00.00’ through 180° 00.00.00’. [0 0.0 0 E]
Figure 70 Recording Settings Menu
Table 13 Record Configuration Items
Menu Item Description Value [Default]
Repeat Record Enables recording over older video data once the hard drive is full.
• When On, at 100%, the on screen display HD Used message
shows “N/A Repeating”. The DVR continues recording
overwriting the first recorded data.
• When Off, at 100%, the on screen display HD Used message
shows “100%. The DVR stops recording.
[On], Off
Record Delay-On Time Enables a time delay after switched power to the DVR is turned on. 0, [30 sec], 1, 5, 10, 20, 30,
45, 60 min
Record Delay-Off Time Enables a time delay to continue recording after the switched power
to the DVR is turned off.
0, [15], 30 sec, 1, 5, 10, 20,
30, 45, 60 min
Power Delay-Off Time Enables a time delay after the record delay-off time expires to keep
the DVR on but not recording. The control connector on the DVR
back panel remains active to allow peripherals such as Smart-Reach
to be powered up during the power delay time.
0, [15], 30 sec, 1, 5, 10, 20,
30, 45, 60 min, 2, 4 hours
Alarm Partition Size Enables a portion of the hard drive to be reserved for alarm data that
needs to be protected and not erased by the Repeat Record function.
[Off], 10, 20, 30, 40%
Overwrite Alarm
Partition
When an Alarm Partition size is selected, enable or disable recording
over older protected alarms once the alarm partition is full.
[Off], On
Table 12 GPS Settings Menu Items
Menu Item Description Value [Default]