Setup guide

Explorer MX-HD Install and Setup Guide
50 700-0159 R003
Signals Menus
Use the Signals menu to configure signals and the actions they generate. The MX-HD supports 10
independent signals. The first five are designated as follows: LT (left turn signal), STP (stop), BRK
(brake), WRN (warning lights), and RT (right turn signal). The last five can be set for other functions. All
of these signals can be used to indicate the status of any indicator, using a maximum of 3 characters.
Figure 66 Signals 1 to 10 Menus
Table 9 Signals 1 to 5 Configuration Items
Menu Item Description Value [Default]
Signal 1 On screen display text for left turn signal. LT, maximum 3 characters
Signal 2 On screen display text for stop signal. STP, maximum 3 characters
Signal 3 On screen display text for brake signal. BRK, maximum 3 characters
Signal 4 On screen display text for warning lights signal. WRN, maximum 3 characters
Signal 5 On screen display text for right turn signal. RT, maximum 3 characters
Signal 6 User generated on-screen display text.
S06, maximum 3 characters
Signal 7
S07, maximum 3 characters
Signal 8
S08, maximum 3 characters
Signal 9
S09, maximum 3 characters
Signal 10
S10, maximum 3 characters
Level Indicates the activation level for the signal.
• (1-5) If Active High is selected, 12 VDC applied to a signal causes the
text to be displayed.
• (1-5) If Active Low is selected, 0 VDC applied to a signal causes the text
to be displayed.
• (6-10) CAN gets a signal from the CAN bus.
• (6-10) J1708 gets signals from the vehicle ECU
[Active H], Active L, CAN,
J1708
Alarm When the alarm setting is enabled, signals can trigger an alarm. See
Alarm
Settings Menus, on page 48.
[Off], Alm 1, Alm 2, Alm 3,
Alm 4