Setup guide

Explorer MX-HD Install and Setup Guide
24 700-0159 R003
21 In the Configuration menu, click Network to edit the Network Settings menu.
22 In the Network Settings menu, click User Levels to assign users access permissions.
23 In the Configuration menu, click System and in System Settings menu, configure as follows.
Setting Type: Leave at default Static IP setting.
Use the IP address shown to communicate with the DVR
over the internet with vMax Web. If the DVR is attached to
a Wi-fi bridge, change these settings to those supplied by the
system administrator.
If the IP information is changed and saved in a configuration
file for upload to other DVRs, their settings will have to be
updated as well. See DVR Configuration Uploads
, on page 30.
Click Back to save the menu settings.
Figure 25 Network Settings Menu
Users logging on to the DVR locally or remotely should
have password control to protect the DVR from being
accidentally reconfigured. Leave the default Admin user and
add other users with access levels as needed.
Enter user names, passwords, and assign levels.
• Admin level user has complete DVR control.
• Configure level cannot edit user levels or IP settings.
• Playback level can only view and archive recordings.
Click Back to save the menu settings.
Figure 26 Network Settings Menu
CAUTION: DVR Password Security
The default password is 11111111. For security purposes, Seon recommends that the user default login
and system settings passwords should be changed. Seon is not responsible if the password is lost or
forgotten.
Disk Full, HD Failure: Leave Off unless your network is
configured to receive emails from the DVR.
Password Enable: Leave Off unless instructed otherwise.
Audio Output Channel: Select the audio channel that will
be available from the audio RCA port on the front of the
DVR.
vMax Web Timeout: Set to 10 minutes.
Click Back to save the menu settings.
Figure 27 System Settings Menu