Setup guide

Explorer MX-HD Install and Setup Guide
22 700-0159 R003
18 In the Alarms and Signals menu, click Alarms.
19 In the Alarms and Signals menu, click Speed.
CAUTION: Select Menu Options for Each Alarm
From the Alarm drop down list, when any alarm (ALM 1, ALM 2, ALM 3, or ALM 4) is selected, ALL
of the settings on the Alarm Settings menu must be configured for that alarm. Configure settings for
each alarm.
Alarm: Alarm 1 comes from the DVR alarm button. Alarm
2-4 can come from signals.
Duration: Applies to Alarm 1 only. Set the Duration for
how long the DVR will record video flagged as an alarm.
Speed, Quality, and Resolution: For each alarm, select
higher settings for better video while the alarm is recording.
Turn off unused channels to avoid DVR video loss events.
Input: Applies to Alarm 1 only. Choose Normally Open or
Normally Closed, depending on the switch type used.
Pre-Alarm: Select how many seconds of pre-alarm video is
included in the flagged alarm recording.
Email: Leave at default unless instructed otherwise.
Wake: Leave at default unless instructed otherwise.
Click Back to save the menu settings.
Figure 22 Alarm Settings Menu
Speed Display : If GPS is installed, select GPS. GPS sensors
are replacing the vehicle speed sensor calibration system.
Speed Units : Choose MPH for US or KPH for Canada.
Click Calibrate if Pulse is selected from Speed Display.
Click Back to save the menu settings.
Figure 23 Speed Settings Menu