Setup guide

Explorer MX-HD Install and Setup Guide
700-0159 R003 21
15 In the Recording Settings menu, click HD Camera.
16 In the Configuration menu, click Alarm/Signal.
17 In the Alarms and Signals menu, click Signals.
The DVR signal harness has 5 dedicated signal input wire connections:
• LT - black wire
• STP - green wire
• BRK - red wire
• WRN - brown wire
• RT - white wire
Leave the camera settings at defaults unless you have
special requirements.
Do not adjust the Advanced Settings unless specifically
instructed to do so.
Click Back
Figure 20 HD Camera Settings Menu
Label: For signals 1-5, labels are provided for left turn,
stop, brake, warning light, and right turn. The labels can be
edited and changed. Signals 6-10 are available for
advanced signal wiring if required. Maximum 3 character
labels.
Level: Set all signal levels as required. Choose Active
High if the circuit you are installing into rests at 0 VDC
and goes to 12 VDC when active. Choose Active Low if
the circuit rests at 12 VDC and drops to 0 VDC when
active.
Alarm: If a signal is used to trigger an alarm, that alarm’s
input must also be set up in the Alarms menu.
Click Back to save the menu settings.
Figure 21 Signals 1 to 5 Menu