Setup guide

Explorer MX-HD Install and Setup Guide
20 700-0159 R003
12 In the Recording Settings menu, click Camera. This example has four interior cameras with
microphones.
13 In the Recording Settings menu, click Record2. Turn off the Camera Speed settings for any unused
cameras.
14 In the Recording Settings menu, click Timers only if you have a specific requirement for timers.
New titles will display here as well as in the play view
overlays.
Speed : Leave the channel speed at default settings unless
you have special requirements. Set any unused cameras’
speed to Off, so the DVR will not generate video loss
events.
Resolution : Leave the channel resolution at default
settings unless you have special requirements.
Quality : Leave the channel quality at default settings
unless you have special requirements
.
Audio: Leave audio settings On unless the camera is
mounted on the exterior of the vehicle.
Click Back to save the menu settings.
Figure 18 Camera Settings Menus
CAUTION: Video Loss Events
When a DVR is installed with less than the full complement of cameras connected, unused camera input
settings must be disabled to prevent the DVR from generating Video Loss (VLoss) events for those
camera inputs. In the DVR Configuration menus, disable unused camera inputs as follows:
• Record Settings menu: Camera Speed OFF, Camera Audio OFF (to save disk space)
• Record2 Settings menu: Camera Speed OFF
• Alarms/Signals menu: Channel Speed OFF
Leave the Enable Timers setting set to Off, unless
instructed otherwise and provided specific start and end
timer information.
The timer function can only operate when the ignition is
on. It cannot be set to record when the vehicle is off.
Figure 19 Timer Settings Menu