Setup guide

Explorer MX-HD Install and Setup Guide
700-0159 R003 19
9 In the Diagnostic Display menu, select options to display as overlays in the play view.
10 In the Configuration menu, click Record.
11 In the Record menu, set up record and power delay timers.
The diagnostic display options are a customer preference.
Leave all these settings On.
Internal Temperature Display : For temperature
measurement display, leave on default F for Fahrenheit
(USA) or choose C for Celsius (Canada).
Click Back to save the menu settings.
Figure 16 Diagnostic Display Menu
Repeat Record : Leave at default for the hard drive to loop
and record over the first recordings when it is full.
Record Delay On Time : Leave at default to let the bus
voltage settle after the bus starts up to prevent voltage
drops affecting the DVR.
Record Delay Off Time : Set to 10-20 minutes to keep the
DVR and cameras on after the ignition turns off to record
the bus post-trip check.
Power Delay Off Time : This starts up after Record Delay
Off time ends. If Wi-fi is used, set to 2 hours or more. If no
Wi-fi, leave at default.
Alarm Partition Size : Leave Off unless instructed
otherwise.
Click Back to save the menu settings.
Figure 17 Recording Settings Menu