Setup guide

Explorer MX-HD Install and Setup Guide
10 700-0159 R003
MX-HD Basic: Alarm Button Installation
To install the alarm button:
1 Mount the alarm button into a ½" hole and attach to the alarm input harness using the micro-fit
connectors.
2 Attach the black wire of the alarm button to the black wire of the alarm input harness.
3 Attach the blue wire of the alarm button to the red wire in the alarm input harness.
4 Connect the alarm input connector to the ALARM input on the DVR.
MX-HD Plus: Smart-Link Installation
To mount the Smart-Link:
1 Mount the Smart-Link using the four #10 × ¾" sheet metal screws or the four #10 × ¾" self-drilling
screws. For the Smart-Link’s dimensions, see Figure 88, Smart-Link Module, on page 68.
2
Connect the constant (red), switched (yellow) 12 VDC lines, fuses, and ground wires as shown in Figure 1.
3 Connect all other optional items such as GPS, G Sensor, alarms, signals, or speed to Smart-Link.
Figure 5 Alarm Button and Alarm Input Harness
Important:
• Choose a dry location with easy access to the electrical panel and cable connections to mount the Smart-Link.
• Always use the supplied fuses to provide over-current protection on the system wiring. The harness kit includes
two fuses for the two 12 VDC lines required to complete this installation.
CAUTION: Power Connections
Connect the constant power and ground wires as close to the battery as possible. Ensure the
connections are safe and secure to reduce potential corrosion or wear that may compromise
performance.