User guide

Operation
3–2 700-0075 R002
Table 3-1 Front Panel Features
Item Feature Description
1
DVR Drive lock
Requires the DVR drive key to unlock and remove the DVR drive.
When the DVR is recording, press the STOP/TEMP PWR button before unlocking and
removing the DVR drive. Turn the drive key to the open position. After ten seconds or until
the red HDD activity indicator is off, gently pull out the drive.
CAUTION: Data Loss
Do not remove the DVR drive until 10 seconds after power to the drive is turned off and the
red HDD activity indicator is off. Failure to do so may result in lost data.
2 DVR Drive
Remove the drive to a separate location for playback using the Media Cartridge Reader
connected to a PC. See “Removing and Replacing the DVR Drive” on page 3–3 and Figure
3-2 on page 3–5.
3
USB1, USB2 ports Supports usb devices for:
• Copying video and audio information.
• Exporting video clips.
• Updating the DVR firmware.
• Importing/exporting.
• Connecting the trackball mouse.
4
LAN activity
(green)
Illuminates when there is network activity on the local area network connection.
5
HDD activity (red)
Illuminates when the DVR is accessing the drive.
6 PWR indicator
(green)
TEMP ---
VOLTAGE — —
Illuminates when the DVR is powered on.
Flashes quickly when the DVR cannot power up due to temperature limitations.
Flashes slowly when the DVR cannot power up due to voltage limitations.
7
AUDIO OUT (red) Audio output RCA jack.
8
VIDEO OUT
(yellow)
Video output RCA jack for configuring the DVR.
9 ONE TOUCH Press to start ONE TOUCH downloading to portable media installed in USB port.
See “Using One-Touch Download” on page 3–16.
10 STOP/TEMP PWR
(red button)
• Power on the DVR temporarily if held for more than 5 seconds.
• Power down the DVR if held for more than 5 seconds when the DVR is in
temporary power mode, or in shutdown sequence.
• Press the STOP button to stop the DVR from recording or playing.
11 infrared (IR) receiver Use with the remote control pointed at the receiver.