User guide

Introduction
700-0075 R002 1–3
Figure 1-2 Typical Plus System
Explorer® MX4
Typical Plus System Setup
Vehicle Electrical Interface
Peripherals
Seon System
Remote Microphone
*2
Smart-Link™
Supports Four Cameras
IR Illuminator
GPS Receiver
*1
8 wires
3 wires
Red - Call Seon if using hall sensor
Green - Speed 6ensor +igh
Black - Speed 6ensor /ow
SPEED
Diagnostic Button
5 wires
Inertia Sensor
Smart-Reach® Mobile (Wi-Fi)
LCD Monitor
*3
Left Turn (black)
Stop (green)
Brake Signal (red)
Warning (brown)
Right Turn (white)
SIGNALS
Alarm 1 (orange)
Alarm 2 (blue)
Alarm 3 (violet)
Alarm 4 (gray)
Alarm 1-4 Ground (black)
4 wires
ALARMS
MX4 DVR Rear Panel
3 wires
Vehicle + 12V (red)
5A
Vehicle Switched + 12V (yellow)
Battery Negative (black)
POWER
1A
Accessories
*1 For speed tracking, use a GPS receiver or speed sensor. For ease of installation and better speed tracking, Seon recommends using a GPS receiver.
*2 The optional remote microphone connected to AUD IN1 (or AUD IN2) can only be used if the camera connected to Camera 1 (or Camera 2) does not have a microphone.
*3 The LCD Monitor can be used for the front or back panel.