User guide

Introduction
1–2 700-0075 R002
The MX4 Plus system consists of the following additional components (see
“Installation Diagrams” on page 1–2):
• Smart-Link™ module
• Cables and harnesses:
• ignition input harness
• power input harness with in-line fuses for constant and switched power lines
• alarms and signals harnesses
• speed harness
• Diagnostic Button (video recording label optional)
• GPS (Global Positioning System) receiver, optional
1.2. Installation Diagrams
The following diagrams show typical MX4 Basic and MX4 Plus installation
connections:
Figure 1-1 Typical Basic System
Explorer® MX4
Typical Basic System Setup
Vehicle Electrical Interface
Peripherals Seon System
Remote Microphone
*1
Alarm Switch
LCD Monitor
*2
Supports Four Cameras
IR Illuminator
3 wires
Vehicle + 12V (red)
Battery Negative (black)
POWER
Vehicle Switched + 12V (yellow)
5A
1A
MX4 DVR Rear Panel
*1 The optional remote microphone connected to AUD IN1 (or AUD IN2) can only be used if the camera connected to Camera 1 (or Camera 2) does not have a microphone.
*2 The LCD Monitor can be used for the front or back panel.