User`s guide

Installation
700-0058 R001 2–9
To connect to the back of the DVR:
1. Plug the 6-pin mini-DIN connector from each camera into the mating
connector on the back of the DVR. See Figure 2-5.
2. Plug one end of the Smart-Link-to-DVR connection harness into the
POWER
IN connector. The connectors on the harness are identical so that either end
can be plugged into either device. See Figure 2-6.
The other end of the Smart-Link-to-DVR connection harness is connected
once the Smart-Link module has been installed. See “2.7. Step 6: Installing
the Smart-Link™ Module” on page 2–11.
3. If an optional external microphone is being used, plug the power connection
into either
POWER 1 or POWER 2.
4. Plug the
RCA connector into the AUDIO IN 1 or AUDIO IN 2 jack. See “2.4.1.
Checking the Camera Cable Connections” on page 2–6 about disconnecting
the audio from a camera when using the external microphone.
5. Push the cables into the cable retainers on the back of the DVR brackets and
slide the DVR into the lock box.
Figure 2-6 Smart-Link-to-DVR connection harness
Important: Take care not to pinch or bind any cables when sliding the DVR into the
lock box.