User`s guide

Installation
700-0058 R001 2–7
The camera cable should be long enough to reach from a camera mounted to the
header or ceiling of a bus down to the DVR lock box. Different cable lengths can
be obtained by contacting Seon Design.
The camera cable can be surface run or concealed.
Surface run
Installation
If the installation is surface run, ensure that the camera cable is secured at multiple
points and is protected from sharp corners.
Concealed
Installation
If the cable is concealed, it can be pulled from either end. Pulling from the
connector end requires larger holes in panels. Pulling from the wire end requires
the cable to be disconnected from the camera.
Feed the cable through the large cable grommet on the DVR lock box. The
connectors can be fed through the grommet one at a time, or the grommet can be
cut at the top and the cables can be simply slid into the grommet. Leave enough
cable in the DVR lock box to allow the DVR to slide all the way back.