User guide

Installation and Setup
2–16 700-0036 R005
2.6. Connecting the HD Reader to a Computer
To connect the HD Reader to your computer:
1. Use the USB cable to connect the HD Reader to a USB 2.0 port on your computer.
2. Connect the power adapter cable to the HD Reader. See Figure 2-3.
3. Plug the AC power cord into the power adapter.
4. Plug the AC power cord into an electrical outlet. See Figure 2-4.
5. Before turning the power switch on the back of the HD Reader to
ON, follow the
instructions for “Inserting a Hard Drive into the HD Reader”.
Important: Install the vMax software before connecting the HD Reader to your computer.
CAUTION: Equipment damage
Before connecting the HD Reader to your computer, make sure the HD Reader is not plugged
into an electrical outlet and the power switch on the back of the HD Reader is OFF.
Figure 2-3 Connecting the HD Reader to your computer
AC power cord
Power adapter
Power adapter cable
HD Reader
Power switch
USB cable
Figure 2-4 Plugging the HD Reader to an AC Outlet